Sometimes I had to press hard on the battery contact to bend it back so that it would make a good connection.Įverything is working properly then put it all back together. If you didn't get a light when recording or playback and you don't hear anything make sure the plastic tab sticking out from one of the batteries on the circuit board isn't still preventing contact to the battery. To play back the recording press the dome button. Release the Record button when done recording. The LED light should stay on while recording but flash once when playing it back. Hold down the Record button on the bottom plate while speaking into the mic. This would be a good time to test again the unit for correct operation. If you haven't pulled the tab from the battery to activate the record / playback please do so before you hot glue it together. If it doesn't trim off those tabs then dry fit it again. It should come to gether and still allow the push button to operate. While holding it all together put the outer shell over the entire assembly. Set the speaker / button dome over the shinny silver thing. Try to line up the corners with those little tabs to hold it in place. Place the shinny silver thing over where the Play back button was glued. Take the main core of the button with the circuit board, speaker, buttons, etc and glue the remaining button (Play back button) to the center of the circuit board. I tried to make them as triangular as possible but just like the rest of the holes in the base plate keep them in side the line. You can do it now or later, pre-drill the holes for the feet. try to place it near one of the 3/8 inch holes like shown in the picture. You may have to start small and work you way up to the size of the LED light. Make another hole using the small dremel drill bit. Try to place them inside but close to that line and the teeth that lock the base plate to the battery compartment. I drill that medium sized hole out to the 3/8 after I started to fit the button and mic.) You will want them on opposite sides. Once you've got it clean make two holes with the drill using the 3/8 bore (The picture below only shows one 3/8 hole. It will take a couple of tries but eventually it will rub off with a cloth soaked with the acetone. I used Acetone which helps loosen and take off that sticky tape. It is in the way so peal off the paper then scratch up the foam tape with a flat head screw driver. Most of the time the base plate comes with that sticky foam tape.

Big mac buttons