does panda pau06 support monitor mode and packet injection

Please download and use the attached test.cap for this tutorialĮxtract and copy the cap to a folder and open a terminal inside.ĭata link type.: 105 (DLT_IEEE802_11) Mydevice is your WLAN device (it must be running allready in monitor mode on a real device - do not use virtual devices like mon0). Wlanresponse -i -o test.cap -t 3 -b -l -L Run wlandump-ng or wlanresponse for a while (one or more hours) using this options: (07-22-2017, 10:07 AM)ZerBea Wrote: basic tutorial about the features to capture passwords from wlantrafficĬhoose a place where you do expect to receive many, many clients.

If you are a Linux newbee (or an unexperienced K A L I user), I can't recommend to use third party or patched firmware/drivers, because you'll run into several issues (at the latest on a kernel update).Ī good start to get an information about driver, driver updates, issues and chipset:īut be warned: Manufacturers often change the chipset, but will use the same case and customary packing! I'll never buy a device if I know that the kernel stock driver doesn't support full monitor mode, full packet injection and ioctl() system calls.īut some times I get a device to test some third party drivers, e.g. I do not use K A L I, because I'm not a penetration tester! We are talking about Linux kernel stock firmware/driversĪnd not about third party firmware/drivers/patches included in special penetration testing distributions (e.g.: K A L I). TX speeds are extremely poor on certain chips (QCA6174 is one). Tx rate is reported as 6mbps due to firmware limitation (no tx rate information in tx completions) instead see /sys/kernel/debug/ieee80211/phyX/ath10k/fw_stats Firmware does not support association to the same AP from different virtual STA interfaces (driver prints “ath10k: Failed to add peer XX:XX:XX:XX:XX:XX for VDEV: X” in that case)Īpplying ath9k regulatory domain hack patch from OpenWRT causes firmware crash (reason: regulatory hint function is never called and ath10k never sends scan channel list to the firmware which in turn causes firmware to crash on scan)

Does panda pau06 support monitor mode and packet injection